Star Brite Marine Descaling Fluid Concentrate 3.79LView all products in Cleaners

Star Brite 83900C Marine Descaling Fluid Concentrate 3.79L

Star brite Descaling Fluid is designed to safely and quickly remove scale, calcium deposits, corrosion, salt and carbon buildup in your raw water-cooled systems.

These deposits can cause your engine to run hot or result in AC system inefficiencies by restricting water flow through the cooling jackets, tubes and heat exchangers. Calcium and scale buildup may also damage your water pumps if debris is dislodged and allowed to flow into the pump housing. Descaling Fluid Will Not damage seals, gaskets, rubber impellers or hoses.

Star brite Marine Descaling Fluid can be recirculated through any system where descaling is needed. Recirculation allows for minimal dismantling and a faster return-to-service for equipment. The product can also be used as a soak by submerging components in the fluid to eliminate deposits.

Mix 4:1 - One part Descaling Fluid concentrate for every four parts fresh water for all applications, including recirculating and soaking.

Directions:

Descaling by Recirculation:

• Isolate and drain the system to be descaled, making sure no raw water can be introduced during the process. Disable the compressor or chiller to prevent operation during descaling. Flush system with fresh water to remove any remaining sea water prior to beginning.
• Properly dilute Marine Descaling Fluid. Fill the system with the required amount* of diluted Descaling Fluid. Set up a recirculating system with a suitable pump in which both inputs and outputs feed/drain solution from a container or bucket. Recirculate for 4-8 hours or until the scale has dissolved. If pump unavailable, allow product to soak in the system for the same time. Do Not seal the system off, as gassing will occur during the process, and excess pressure may cause damage.
• Drain solution from system and dispose in accordance with local, state and federal laws.
• Flush the system with fresh water to remove any remaining descaling fluid, then reassemble properly. It is recommended that all sacrificial anodes be replaced at this time.

• Properly dilute Marine Descaling Fluid. Fully submerge equipment in diluted solution for 4-8 hours or until scale has dissolved. Rinse with fresh water.