Wire Bullet blocks use roller bearings to carry higher loads and feature Hard Lube-anodized PTFE-impregnated aluminum sheaves for strength and corrosion resistance.
The 1" wire block uses low-friction thrust washers and handles wire up to 2mm in diameter or 4mm high-strength rope control lines on boats of all sizes.
It accepts wires up to 1/8" (3mm) in diameter. 1-1/2" Sheave with high-load composite bearings to carry axial loads and sideload balls between the sheave and the side plate, minimizing friction from unfair leads.
We will answer your question and send you details within 24 hours.
Because our price on this item is lower than the manufacturer's Minimum Advertised Price, the manufacturer doesn't allow us to display our retail price until you place the item in your shopping cart.
Adding the item to your cart allows The Binnacle to show you our price; consistent with our goal of offering the lowest possible price on the widest selection of products.
Adding this product doesn't require you to purchase the item, and you can easily remove it from your cart if you decide not to buy it.
Your feedback has been forwarded to Binnacle.com. Your feedback will be reviewed and considered carefully. If your feedback requires a response, we expect to email you a reply within 24 hours (Monday to Friday).
CATEGORY: Harken Wire Blocks 
